To Investigate Effect On Surface Roughness For The Stainless Steel 304 Materials In CNC Lathe Machining

Moganaganes , Sundaram Murgan (2009) To Investigate Effect On Surface Roughness For The Stainless Steel 304 Materials In CNC Lathe Machining. Project Report. UTeM, Melaka, Malaysia. (Submitted)

	PDF (24 Pages) To_Investigate_Effect_On_Surface_Roughness_For_The_Stainless_Steel_304_Materials_In_CNC_Lathe_Machining_-_Moganaganes_AL_Sundaram_Murgan_-_TJ1191.M63_2009_24_Pages.pdf - Submitted Version Download (493kB)
	PDF (Full Text) To_Investigate_Effect_On_Surface_Roughness_For_The_Stainless_Steel_304_Materials_In_CNC_Lathe_Machining_-_Moganaganes_AL_Sundaram_Murgan_-_TJ1191.M63_2009.pdf - Submitted Version Restricted to Registered users only Download (5MB)

Abstract

The project of investigation of cutting parameters influences the stainless steel grade 304 surface roughnesses with CNC turning machining process is divided in two parts. First part of the project is about proposal and the second part is about project implementation or experimental. This report fully describes about the combination of both part, which contains six chapters starting from introduction, literature review, methodology, results, discussion and conclusion respectively. The first chapter describes about scope and objective of the project and expected results. The main objectives of the project are to investigation of cutting parameters influences to recommended the optimized parametric to produce good cutting quality for stainless steel grade 304 by using CNC lathe. While the second chapter is discusses about literature review. The literature search is performed to study, analyses and understand the basic fundamental of CNC turning process. The next chapter is methodology. This chapter was describes the steps or procedures that are used to complete this project. In this project the experiment was conducted due to the design of experiment data (D.O.E). Therefore, some experimental results are obtained and described in chapter four such as surface quality measurement by using Profilometer which is equipped in FKP laboratory. The following chapter is discusses about the result, problems and suggestion to overcome the problems. Finally, the overall project and its achievements are concludes in chapter six.

Actions (login required)

View Item