Development Of Modular Jigs And Fixture For CATIA

Soo, Wai Hong (2007) Development Of Modular Jigs And Fixture For CATIA. Project Report. UTeM, Melaka, Malaysia. (Submitted)

	PDF (24 Pages) Development_Of_Modular_Jigs_And_Fixture_For_CATIA.pdf - Submitted Version Download (291kB)
	PDF (Full Text) Development_Of_Modular_Jigs_And_Fixture_For_CATIA.pdf - Submitted Version Restricted to Registered users only Download (2MB)

Abstract

The title of this project is Development of Modular Jig and Fixture for CATIA. The purpose of carrying out this project is to investigate the development of modular jig and fixture using the CATIA software. This project will enable students to increase their knowledge on modular jig, fixture and also the CATIA software. In the initial step of the project, many researches are done to gather information. After that, the information is gathered to create the sketch drawing which is the basic before designing the jig and fixture. When the design is ready, a library is added to the CATIA software and also the assembly and testing process. If a problem occurred during the testing process, the jig and fixture design is modified and re-tested until the required result is obtained. Finally, discussion of the result obtained are stated and some recommendations to help improve further research of the project. At the end of the report, a conclusion is drawn out from the result obtained which states on how good and further improvement that can be made for this project.

Actions (login required)

View Item