Analysis On CAD Data Obtained From Non-Contact Reverse Engineering System

Mohd Helmi, Md Salleh (2012) Analysis On CAD Data Obtained From Non-Contact Reverse Engineering System. Project Report. UTeM, Melaka, Malaysia. (Submitted)

	PDF (24 Pages) Analysis_On_Cad_Data_Obtained_From_Non-Contact_Reverse_Engineering_System_-_24_Pages.pdf - Submitted Version Download (456kB)
	PDF (Full Text) Analysis_On_Cad_Data_Obtained_From_Non-Contact_Reverse_Engineering_System.pdf - Submitted Version Restricted to Registered users only Download (2MB)

Abstract

This report covers the final year project undertaken by student in University Technical Malaysia Melaka (UTeM) for fulfill the university requirement to graduation. This report describe about the project titled “Analysis on CAD Data Obtained from Non- Contact Reverse Engineering System”. The purpose of this project is to analyze and compares the STL file as a CAD data obtained from the two types of reverse engineering technology machines which are REXCAN structure light 3D scanning and FARO ARM laser scanning. These two types of reverse engineering machine will be compared and analyzed the STL file in term of its overlapped triangles (bad contour) and gap between edges (bad edge). This report also compares the total time required to scan an object. This report is divided into five chapters. Chapter one presents the introduction of this project. Then chapter two presents the literature review on the reverse engineering, 3D scanner, CAD file and some of the previous studies about RE and STL file. Chapter three describes the experimental works and methodology on how this project will be done and on how the experimental being done to come out the result. Next in chapter four, the result of the experimental had been show and the discussion of the result is made. Lastly the chapter five is including the conclusion and recommendation of the project.

Actions (login required)

View Item