Propose New Dust Suction System To Solve The Malfunctioning Of Existing System In The Trim Booth At Manufacturing Industry

Pan, Carol Zi Ting (2017) Propose New Dust Suction System To Solve The Malfunctioning Of Existing System In The Trim Booth At Manufacturing Industry. Project Report. UTeM, Melaka, Malaysia. (Submitted)

Text (24 Pages) Propose New Dust Suction System To Solve The Malfunctioning Of Existing System In The Trim Booth At Manufacturing Industry.pdf - Submitted Version Download (652kB)

Abstract

Current manual trim booth has been used for the past four years in CTRM. Carbon dust are produced during the trimming process. However, the dust are all trapped in the drain and cannot be sucked up by the existing dust suction system. Therefore, time and manpower to carry out a manual cleaning up of the dust are required. However, the manual cleaning up will bring a hazardous health effect to the workers as the carbon dust will block the blood circulatory system if it accidentally enter the blood vessels of the workers. Besides that, the dust particle will be trapped in the air and stick to the wall and floor. This will contaminate the part surface because there is no blowing system or air outlet system. Hence a poor quality of part is being produced. Therefore, an effective and budget solution is needed to solve the problem so that the health of the CTRM staffs can be guaranteed and to make sure the time and manpower are not wasted and can be used in the right position. After several researches on the internet and comparison between each of the dust collector system, Airwall is proposed to CTRM because it has the highest efficiency and it is the most cost effective dust collector system among all the systems.

Actions (login required)

View Item