Design and analysis of a plastic book mark injection mould

Zakaria, Ahmad Zikri (2016) Design and analysis of a plastic book mark injection mould. Project Report. Universiti Teknikal Malaysia Melaka, Melaka, Malaysia. (Submitted)

	Text (24 Pages) Design And Analysis Of A Plastic Book Mark Injection Mould 24 Pages.pdf - Submitted Version Download (536kB)
	Text (Full Text) Design and analysis of a plastic book mark injection mould.pdf - Submitted Version Restricted to Repository staff only Download (8MB)

Abstract

This final year project is about “Design and Analysis of a Plastic Book Mark Injection Mould”. This project is focused on the design of the book mark and then optimize the dimension of the gate and determine the best plastic material for the design of a Plastic Book Mark. The design of the Plastic Book Mark and the two cavity mould that used were designed using CATIA V5R20 software. Then, the Autodesk Simulation Moldflow Adviser (SMA) software is used to analyse the optimum gate size for the two cavity Plastic Book Mark. Some of the plastic material used for determining the best one is Polyvinyl chloride (PVC), Polypropylene (PP), High-Density Polyethylene (HDPE), Low-Density Polyethylene (LDPE) and Polyethylene (PET). This project can start with analysing the suggested of several dimensions of the gate size by using the SMA software of existing design. Then, the optimum gate size dimension and the suitable material, are determined according to the SMA analysis.

Actions (login required)

View Item