Multiple Valve Spring Compressor (MVC)

Vinod Kumar, Isweran (2015) Multiple Valve Spring Compressor (MVC). Project Report. UTeM, Melaka, Malaysia. (Submitted)

Text (24 Pages) Multiple Valve Spring Compressor (MVC).pdf - Submitted Version Download (356kB)

Abstract

"Multiple valve spring compressor" (MVC) is a project implemented by modifying the "Valve-Clamp" is used to open and reinstall "valve spring". This serves to open and reinstall "valve spring" in eight valves simultaneously at the "cylinder head” powered by "hydraulic jack". Often mechanics need to use a lot of time and energy when using the "Valve-Clamp". In addition, the mechanics are also exposed to the risk of injury and loss "retainer pin" when open "valve spring" using the old method of using a hammer. The aim of this study was to increase the productivity, due to the designs ability to compress more than one valve spring at a time. Ergonomic design and safety factor were given consideration for the design flows. Results show that the “MVC” rating for left and right hand side are mostly 1 until 5 and the eye view of the “MVC” is clear and more precise. By using "MVC" project is less time consuming and also applicable to all types of car engine. Besides, it won't damage the valve seal as well as many other engine parts. But this project will prevent this damages as there are more safety measures applied. The entire project is successful when we try to complete this project with a variety of methods and design within a few months and has been successful when run an experiment on this project.

Actions (login required)

View Item