The Design Of Motorcycle Rim Adjusting Jig Using Dial Gauge

Mahamad, Khairul Izlan (2008) The Design Of Motorcycle Rim Adjusting Jig Using Dial Gauge. Project Report. UTeM, Melaka, Malaysia. (Submitted)

	PDF (24 Pages) The_Design_Of_Motorcycle_Rim_Adjusting_Jig_Using_Dial_Gauge_-_Khairul_Izlan_b_Mahamad_-_TJ1187.K43_2008_24_Pages.pdf - Submitted Version Download (479kB)
	PDF (Full Text) The_Design_Of_Motorcycle_Rim_Adjusting_Jig_Using_Dial_Gauge_-_Khairul_Izlan_b_Mahamad_-_TJ1187.K43_2008.pdf - Submitted Version Restricted to Registered users only Download (9MB)

Abstract

Motorcycle Rim Adjusting Jig is used for wheel alignment of motorcycle tyre. This jig is very familiar especially at the workshop’s motorcycle service centre. Current jig that has in the market is very hard to operate and require more time for this process. So, new jig is designed to overcome these problems. The jig designed considers the time and techniques of application. Time is reduced and the technique became much easier. This report intends to design new jig with improvement technique during adjustment rim process, which is uses the dial gauge concept. It saves time and facilitates the job process. In fact, results are more precise and accurate because the dial gauge is very sensitive upon differentiations. An information about the functions and aspects involve with the current jig will discussed for benchmark. It sets out rules which will be used to design the new jig that facilitate the adjustment process. Several conceptual designs and detailed design has been built. The jig’s design is then being analyzed and fabricated. Finally, it structures has been tested by using COSMOSworks 2007 Software in order to get a sound product.

Actions (login required)

View Item